LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Engine - V8 S/C 5.0L Petrol -- XE/(760)) >> Engine - V8 S/C 5.0L Petrol, Project 8 (G2261898) >> Removal And Installation >> Crankshaft Rear Seal (G2244072) >> Removal

Crankshaft Rear Seal (G2244072): Removal

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING .

  2. Disconnect the startup battery ground cable.

    Refer to: BATTERY .

  3. Remove the drive plate.

    Refer to: DRIVE PLATE .

  4. G11285382Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the 12 bolts from the crankshaft rear oil seal.
    • Remove and discard the crankshaft rear oil seal.
scientia non olet · About LEMON Manuals