LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Parking Brake And Actuation -- XE/(760)) >> Parking Brake And Actuation (G1822069) >> General Procedures >> Electric Park Brake Release When The Vehicle Has No Electrical Power - Project 8 (G2246237) >> Adjustment

Electric Park Brake Release When The Vehicle Has No Electrical Power - Project 8 (G2246237): Adjustment

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install a new O-ring seal.
    • Install the Electric Parking Brake (EPB) actuator.
    • Install 2 new bolts.

    Renew Part: Electric park brake actuator fitting kit  Quantity: 1. 

    Torque  : 8Nm 

  2. Connect the EPB electrical connector.
  3. Calibrate the EPB using the Jaguar Land Rover approved diagnostic equipment.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

  4. Install the rear wheel and tire assembly.

    Refer to: WHEEL AND TIRE

scientia non olet · About LEMON Manuals