Parking Brake - Project 8 (G2231195): Operation: Service

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Functional test

The Electric Park Brake (EPB) incorporates a vehicle inspection mode that allows a functional test of the park brake to be completed on a rolling brake tester.

Brake Pad Replacement

To change the rear brake pads it is necessary to fully retract the ball screw drive to allow retraction of the brake caliper piston. This can be completed using 1 of the following methods:

Activate the service mode function using the Jaguar Land Rover (JLR) approved diagnostic equipment.
Activate the service mode function without the JLR diagnostic equipment.
Remove the actuators from the brake calipers when the vehicle has no electrical power.

For additional information, Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION / ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL POWER - PROJECT 8