Toe Link (G1823026): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the toe link.
- Tighten the inner nut and bolt finger tight at this stage.
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.

Install and tighten the toe link outer nut and bolt.

Renew Part: Toe link to knuckle bolt(s) Quantity: 1 .

Renew Part: Toe link to knuckle nut(s) Quantity: 1 .

Torque

Stage 1: 80Nm

Stage 2: 60°
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.

Install and tighten the inner nut and bolt.

Renew Part: Toe link to subframe nut Quantity: 1 .

Renew Part: Toe link to subframe bolt Quantity: 1 .

Torque

Stage 1: 60Nm

Stage 2: 90°
Install the rear subframe.
Refer to: REAR SUBFRAME
NOTE: Using Jaguar Land Rover approved equipment, check and if necessary adjust the wheel alignment. SRO must be claimed separately.

Check the wheel alignment and adjust if required.

Refer to: WHEEL ALIGNMENT