Rear Wheel Bearing (G1999312): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.

Before replacing the Rear Wheel Bearing, make sure to have followed the diagnosis and testing procedure.
Refer to: WHEEL BEARINGS
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: WHEEL KNUCKLE
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Special Tool(s): 204-726, JLR-204-836

General Equipment: Hydraulic press
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

General Equipment: Punch

General Equipment: Vise
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Special Tool(s): 204-305

General Equipment: Hydraulic press
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean and inspect the components for deterioration.
NOTE: Note the orientation of the clips prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: Note the orientation of the component prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Special Tool(s): 204-726

General Equipment: Hydraulic press
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean and inspect the components for deterioration.