Rear Stabilizer Bar Link (G1818218): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use a wrench on the hexagon provided to prevent the ball joint rotating.
- Install the rear stabilizer bar link.
- Tighten the 2 nuts to the correct torque.
  Renew Part: Stabilizer bar link nuts Quantity: 2 .
  
  Torque : 48Nm
Install the wheel and tire assembly.
Refer to: WHEEL AND TIRE