Inspection And Verification
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.
- Only serviceable items can be renewed or adjusted. Failure to follow this instruction may result in the warranty of the component being rejected
NOTE:
- If a control module or a component is at fault and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures information, or determine if any prior approval program is in operation, prior to the installation of a new module/component.
- Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
- Verify the customer concern
- Visually inspect for obvious signs of mechanical or electrical damageVISUAL INSPECTION
MECHANICAL - Front left halfshaft oil seal leakage
- Front right halfshaft O-ring oil seal leakage
- Front driveshaft pinion oil seal leakage
- Front differential breather tube
- Front differential assembly
- Front right halfshaft support bracket
- Front right halfshaft
- Front left halfshaft
- Engine oil pan
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
- If the cause is not visually evident, verify the symptom and refer to the symptom chart, alternatively check for Diagnostic Trouble Code(s) (DTC)s and refer to the DTC index