JAGUARDRIVE SWITCHPACK DATALOGGER Signals
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
| DATALOGGER SIGNAL |
DESCRIPTION |
CONTROL MODULE CAVITY |
DTC
S |
| Button State - One Button - Winter mode select switch (0x9B12) |
- This parameter shows if the status of the winter mode switch is pressed or not pressed
- If a fault is evident, Using the Jaguar Land Rover approved diagnostic equipment, check the JaguarDrive Switchpack for DTC
s and repair as necessary
|
- Circuit reference - WTR/DYN SW RTN -
- Circuit reference - WTR/DYN SW FEED -
|
- B104A-11
- B104A-12
- B104A-13
|
| Button State - Two Button - Dynamic Stability Control (DSC)/Eco toggle switch (0x9B12) |
- This parameter shows if the status of the DSC
/Eco toggle switch is pressed or not pressed
- If a fault is evident, Using the Jaguar Land Rover approved diagnostic equipment, check the JaguarDrive Switchpack for DTC
s and repair as necessary
|
- Circuit reference - DSC
/Eco SW RTN -
- Circuit reference - DSC
/Eco SW FEED -
|
- B104B-11
- B104B-12
- B104B-13
|
| Button State - Three Button - All surface progress control switch (0x9B12) |
- This parameter shows if the status of the all surface progress control switch is pressed or not pressed
- If a fault is evident, Using the Jaguar Land Rover approved diagnostic equipment, check the JaguarDrive Switchpack for DTC
s and repair as necessary
|
- Circuit reference - ASPC SW RTN -
- Circuit reference - ASPC SW FEED -
|
- B104C-11
- B104C-12
- B104C-13
|