Low Pressure Fuel Pump Assembly (G2767432): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

The following step(s) applies to:

All vehicles

Connect the 2 fuel pipes and the electrical connector.
Install the fuel pump and sensor unit.
Using the special tool, install the retaining ring.
Special Tool(s): 310-123
Connect the 2 fuel pipes.
Connect the 2 electrical connectors.
Install the access cover.
The following step(s) applies to:

Vehicles without seatbelt retention bar
Install the second row seat cushion.
Refer to: SECOND ROW SEAT CUSHION - PROJECT 8

The following step(s) applies to:

Vehicles with seatbelt retention bar
Secure the trim panel to the 4 clips.
CAUTION: Protect the surrounding paintwork to avoid damage.

With assistance, install the seatbelt retention bar.
Install the 4 lower bolts to the seatbelt retention bar.
Torque : 30Nm
Install the 4 upper bolts to the seatbelt retention bar.
Torque : 30Nm
Secure the 4-point harness to the seatbelt retention bar.
The following step(s) applies to:

All vehicles
Connect the 12 V system.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT