Front Row SEATBELT Buckle - Project 8 (G2247566): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

The following step(s) applies to:

Non NAS vehicles

NOTE: If equipped.
- Install the front row seatbelt buckle.
- Install and tighten the new bolt.
  Renew Part: Seatbelt buckle bolt(s) Quantity: 1 .
  
  Torque : 40Nm
- Secure the 2 wiring harness clips.
NOTE: If equipped.
- Connect the electrical connector.
- Secure the 2 wiring harness clips.
- Install the front row seatbelt buckle.
- Install and tighten the new bolt.
  Torque : 40Nm
- Secure the 3 wiring harness clips.
- Connect the electrical connector.
- Secure the wiring harness clip.
The following step(s) applies to:

NAS vehicles
- Install the front row seatbelt buckle.
- Install and tighten the new bolt.
  Torque : 40Nm
- Secure the 3 wiring harness clips.
- Connect the 2 electrical connectors.
- Secure the wiring harness clip.
The following step(s) applies to:

All vehicles
Install the front row seat.
Refer to: FRONT ROW SEAT - PROJECT 8
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT