Pinpoint Test C: SEATBELT Retractor-Webbing Guide Loose

1. Refer to the appropriate repair information, remove any trim panels required to expose the D loop (anchor point) and seatbelt retractor
2. Check the webbing is not trapped or twisted and is centrally located on the seatbelt retractor spindle
3. Attempt to withdraw the webbing from the seatbelt retractor
   NOTE: If the seatbelt webbing is jammed, the automatic locking retractor could be engaged
4. To release the automatic locking retractor, manually wind the webbing onto the spindle until the automatic locking retractor deactivates (clicking stops)
5. Fully extract webbing
6. Confirm webbing guide location is correct, Confirm the fixing lugs are correctly located in the retractor frame
7. Allow webbing to retract
8. Check for correct operation twice 

Does the webbing move freely then retract correctly?

Yes 

Refer to the appropriate repair information, reinstall any trim panels, make sure there are no obstructions and the webbing does not catch or rub. No further action required

No 

GO to PINPOINT TEST D .