LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Engine Cooling - INGENIUM I4 2.0L Petrol -- XE/(760)) >> Engine Cooling - INGENIUM I4 2.0L Petrol (G2006213) >> Removal And Installation >> Coolant Pump (G1998226) >> Installation

Coolant Pump (G1998226): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coolant pump.

    Torque  : 12Nm 

  2. Connect the electrical connectors.
  3. Install the coolant pump pulley. Hand tighten the bolts at this stage.
  4. CAUTION: Make sure that the accessory drive belt is correctly located on each pulley.
    1. Install the accessory drive belt.
    2. Release the accessory drive belt tensioner.
  5. Fully tighten the coolant pump pulley bolts.

    Torque  : 25Nm 

  6. Install the intake air resonator.

    Refer to: INTAKE AIR RESONATOR

  7. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

  8. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals