LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Engine Cooling - INGENIUM I4 2.0L Petrol -- XE/(760)) >> Engine Cooling - INGENIUM I4 2.0L Petrol (G2006213) >> Removal And Installation >> Block Heater (G2033416) >> Installation

Block Heater (G2033416): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Replace the gasket if it is worn.
    • Install the gasket.
    • Install and tighten the block heater.

    Torque  : 55Nm 

  2. Connect the electrical connector.
  3. Install the generator.

    Refer to: GENERATOR

  4. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals