Constant Velocity Joint Boots (G2257945): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
The constant velocity joint boots are supplied as a pair.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the rear halfshaft.
Refer to: REAR HALFSHAFT - PROJECT 8
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the 2 retaining clips.
CAUTION: Care must be taken not to damage the component.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Position the halfshaft in a vise as illustrated.

General Equipment: Vise
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the inner Constant Velocity (CV) joint.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable soft drift, strike the bearing mount in the indicated area until the circlip can be accessed.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the circlip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool remove the bearings.

Special Tool(s): 303-D121
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the inner CV joint boot.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the 2 retaining clips.
Remove and discard the outer CV joint boot.