Constant Velocity Joint Boots (G2257945): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Clean and inspect the outer Constant Velocity (CV) joint for deterioration.
- Pack the outer CV joint with the grease supplied.
  Renew Part: Inner and outer constant velocity joint boot kit Quantity: 1.
- Install the new outer CV joint boot to the outer CV joint.
NOTE:
- Make sure the outer Constant Velocity (CV) joint boot is correctly installed
- Make sure the retaining clip is correctly seated.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool, install the 2 retaining clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the new inner CV joint boot and retaining clip.
Using a suitable soft drift, install the bearings.
Install a new circlip.
Renew Part: Circlip Quantity: 1.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Clean and inspect the inner CV joint for deterioration.
- Pack the inner CV joint with the grease supplied.
- Install the inner CV joint.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Secure the inner CV joint boot to the inner CV joint.
NOTE:
- Make sure the inner Constant Velocity (CV) joint boot is correctly installed.
- Make sure the retaining clip is correctly seated.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool, install the retaining clips.
Install the rear halfshaft.
Refer to: REAR HALFSHAFT - PROJECT 8