Rear Proximity Camera (G1829860): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that this component is installed to the noted removal position.

To install, reverse the removal procedure.
NOTE: If a new component is installed.

Use the Jaguar Land Rover approved diagnostic equipment to configure the rear proximity camera.

General Equipment: Jaguar Land Rover approved diagnostic equipment
- Following the replacement of a camera on these vehicles the calibration process is:
- Drive the vehicle for 5 to 10 minutes as much as possible in a straight line, up to 30kph/19mph, during this time the camera will self-calibrate (do not have the camera functions turned on) to be carried out in normal daylight conditions.
- After completing the drive cycle camera operation can be checked by:
- Surround View Camera: To check calibration parked next to a kerb/line select camera view make sure a straight line is visible on screen in the 360 plan view
- Standalone Rear Camera To check calibration reverse straight into a marked parking slot and see trajectory overlays are parallel to the markings on the ground