LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Parking Aid -- XE/(760)) >> Parking Aid (G1817327) >> Removal And Installation >> Front Proximity Camera (G1829858) >> Installation

Front Proximity Camera (G1829858): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
    • Following the replacement of a camera on these vehicles the calibration process is:
    • Drive the vehicle for 5 to 10 minutes as much as possible in a straight line, up to 30kph/19mph, during this time the camera will self-calibrate (do not have the camera functions turned on) to be carried out in normal daylight conditions.
    • After completing the drive cycle camera operation can be checked by:
    • Surround View Camera: To check calibration parked next to a kerb/line select camera view make sure a straight line is visible on screen in the 360 plan view
    • Standalone Rear Camera To check calibration reverse straight into a marked parking slot and see trajectory overlays are parallel to the markings on the ground
scientia non olet · About LEMON Manuals