Image Processing Module (G1913448): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.
NOTE: Vehicles to the end of 17MY.

If a new Image Processing Module 'A' (IPMA) is installed, the Jaguar Land Rover approved diagnostic equipment must be used to calibrate the module.
NOTE:
- Vehicles from introduction of 18MY.
- The drive cycle must not be completed in dark or foggy conditions. The vehicle must not be loaded. Use straight roads wherever possible. Do not travel closely to the vehicle in front.

If a new IPMA is installed. The Jaguar Land Rover approved diagnostic equipment must be used to calibrate the module.
Select 'IPMA '
Select 'Replace ECU'
Follow all on-screen instructions to complete this task.