Service Indicator Reset (G1821737): Synchronization
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the Jaguar approved diagnostic equipment is not connected to the vehicle.
- Set the ignition to the ON position.
- Open the hood.
- Open the drivers door.
-
NOTE: If the accelerator pedal pressed before the brake pedal this will cause Brake Over Accelerator (BOA) logic and will default the accelerator pedal to 0%. If this happens the service reset procedure will have to be restarted.
Fully depress the brake pedal then the accelerator pedal and hold for 10 seconds.
-
NOTE: A service resetting message will appear on the instrument cluster.
Release the accelerator and brake pedals and set the ignition to the OFF position.
- Set the ignition to the ON position and check the message has been cleared.
- If the message remains, repeat the process.