Starter Motor (G2244124): Removal

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe due care when working near a hot exhaust system.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the right side catalytic converter for access only.
Refer to: RIGHT CATALYTIC CONVERTER
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the heatshield.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 2 clips and remove the cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 nuts.
- Position the 2 cables to one side.
NOTE: Make sure the starter motor is fully supported at this stage. Do not allow the starter motor to hang from the wiring harness.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Position the starter motor to one side.
NOTE: Make sure the starter motor is fully supported at this stage. Do not allow the starter motor to hang from the wiring harness.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the nut.
- Remove the starter motor.