Transfer Case Rear Output Seal (G1917366): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the driveshaft.
Refer to: DRIVESHAFT - INGENIUM I4 2.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool, remove and discard the rear output flange nut and seal.

Special Tool(s): 205-053
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool, remove the rear output flange.

General Equipment: Puller
WARNING: Be prepared to collect escaping oil.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool, carefully remove and discard the rear output seal.
CAUTION: Make sure that an approved cleaning fluid is used to clean the mating faces.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Thoroughly clean the rear output shaft and flange splines.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean the seal register and thoroughly inspect for damage.