Transfer Case Rear Output Seal (G1917366): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool, install the new rear output seal.

Special Tool(s): 307-520 , JLR-307-695
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Apply a 1 mm diameter bead of sealant meeting specification to the output flange splines.

Refer to: SPECIFICATIONS
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the rear output flange.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool, renew the rear output flange nut and seal.

Special Tool(s): 205-053

Renew Part: Transfer case rear output shaft flange nut Quantity : 1.

Renew Part: Transfer case rear output shaft flange oil seal Quantity : 1.

Torque : 160Nm
Install the driveshaft.
Refer to: DRIVESHAFT - INGENIUM I4 2.0L PETROL
Check transfer case fluid level.
Refer to: TRANSFER CASE FLUID LEVEL CHECK