Transfer Case Front Output Seal (G1917365): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tools install a new front output seal.

Special Tool(s): JLR-307-696 , 307-596

Renew Part: Transfer case front output shaft oil seal Quantity : 1.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install a new circlip.

Renew Part: Transfer case front output shaft snap ring Quantity : 1.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the drive flange.
CAUTION: Make sure that new bolts are installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the driveshaft to flange bolts.

Renew Part: Driveshaft to front output flange bolts Quantity : 1.

Torque

Stage 1: 40Nm

Stage 2: 90°
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

A new breather vent must always be installed.

Renew Part: Breather Quantity : 1.
Fill the transfer case.
Refer to: TRANSFER CASE DRAINING AND FILLING