Transfer Case Draining And Filling (G1908027): Draining

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the air deflector.
Refer to: ENGINE UNDERSHIELD - PROJECT 8
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the caps.
- Remove the 2 nuts and the Noise, Vibration and harness (NVH) damper.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 3 bolts and the NVH damper bracket.
Position a container to collect the fluid.
CAUTION: Make sure that the area around the component is clean and free of foreign material.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the drain plug and allow the fluid to drain.
CAUTION: Make sure that the area around the component is clean and free of foreign material.

NOTE: Do not discard the drain plug.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the drain plug and allow the fluid to drain.