LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Transfer Case Vehicles With: 8HP45 8 - Speed Automatic Transmission AWD/8HP70 8 - Speed Automatic Transmission AWD -- XE/(760)) >> Transfer Case - Vehicles With: 8HP45 8-Speed Automatic Transmission AWD/8HP70 8-Speed Automatic Transmission AWD (G1904671) >> Diagnosis And Testing >> Transfer Case >> Pinpoint Tests >> Pinpoint Test A: Transfer Case Clutch Lock-Up Tests

Pinpoint Test A: Transfer Case Clutch Lock-Up Tests

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. A1: TRANSFER CASE CLUTCH LOCK-UP TEST 1 
    NOTE:
    • The transfer case clutch status can be viewed on the touchscreen through the All Surface Information screen.
    • When the transfer case clutch is disengaged, the front driveshaft will  rotate independently of the rear driveshaft.
    1. Make sure that the transmission is set to Park
    2. Raise the vehicle on a lift so that the wheels are free of the ground
    3. Hold one front wheel and attempt to rotate the other front wheel

    Will the front wheel, front halfshaft and the front driveshaft rotate?

    Yes:  Transfer case clutch not engaged. GO to A2  .

    No:  Transfer case clutch engaged. Install a new transfer case. Raise a prior approval request for a new transfer case. Attach evidence of your findings to the prior approval request. A transfer case prior approval request will not be approved without evidence of the pinpoint test being completed

  2. A2: TRANSFER CASE CLUTCH LOCK-UP TEST 2 
    NOTE: The transfer case clutch status can be viewed on the touchscreen through the All Surface Information screen.
    1. Make sure that the transmission is set to Park
    2. Using the Jaguar Land Rover approved diagnostic equipment, perform routine - Lock Centre Differential

    Is the transfer case actuator operation audible?

    Yes:  Transfer case actuator active. GO to A3  .

    No:  Transfer case actuator inactive. Check the transfer case actuator circuit for short circuit to ground, short circuit to power, open circuit, high resistance Repair the wiring harness as necessary

  3. A3: TRANSFER CASE CLUTCH LOCK-UP TEST 3 
    NOTE:
    • The transfer case clutch status can be viewed on the touchscreen through the All Surface Information screen.
    • When the transfer case clutch is engaged, the front driveshaft will not  rotate independently of the rear driveshaft.
    1. Make sure that the transmission is set to Park
    2. Raise the vehicle on a lift so that the wheels are free of the ground
    3. Using the Jaguar Land Rover approved diagnostic equipment, perform routine - Lock Centre Differential. Hold one front wheel and attempt to rotate the other front wheel

    Will the front wheel, front halfshaft and the front driveshaft rotate?

    Yes:  Transfer case clutch not engaged. GO to A4  .

    No:  Transfer case clutch engaged. Transfer case clutch operating correctly

  4. A4: TRANSFER CASE CLUTCH LOCK-UP TEST 4 
    1. Refer to the relevant article of the repair information and check the transfer case fluid level

    Is the fluid level correct?

    Yes:  Install a new transfer case actuator and retest. If the fault persists, install a new transfer case. Raise a prior approval request for a new transfer case. Attach evidence of your findings to the prior approval request. A transfer case prior approval request will not be approved without evidence of the pinpoint test being completed

    No:  Rectify any fluid leaks, adjust the fluid level as necessary and retest. GO to A3  .

scientia non olet · About LEMON Manuals