DTC P0702-04: Transmission Control System Electrical - System internal failures: Action
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- Prioritized steps to perform:
- Check battery charge and condition. Record the observed values
- Using the Jaguar Land Rover approved diagnostic equipment, read all DTCs and investigate any DTCs relating to battery voltage supply
- Inspect the transmission connector(s) for signs of water ingress, pin damage and/or corrosion. Rectify as required
- Using the Jaguar Land Rover approved diagnostic equipment, check datalogger signal - Main ECU Supply Voltage (0xD112)
- Refer to the electrical circuit diagrams, record the observed values for the transmission control module VBATT, ground and IGN circuits then check for open circuit, high resistance. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, reconfigure the transmission control module with the latest level software
- Clear DTCs and retest
- If the fault persists, raise a Technical Assist (TA) for further support