LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Automatic Transmission/Transaxle - RWD -- XE/(760)) >> Automatic Transmission/Transaxle - RWD (G1868372) >> Removal And Installation >> Selector Shaft Seal (G1868145) >> Removal

Selector Shaft Seal (G1868145): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some illustrations may show the transmission removed for clarity.
  1. Refer to: ENGINE UNDERSHIELD
  2. G11291966Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  3. CAUTION:
    • Before the disconnection or removal of any components, make sure the area around joint faces and connections are clean. Plug any open connections to prevent contamination.
    • Discard the seal.
    G11291967Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Install 307-509-1 to the seal.

      Special Tool(s): 307-509-1 

    • Install 307-509-2 to 307-509-1 and extract the seal.

      Special Tool(s): 307-509-2 

scientia non olet · About LEMON Manuals