Extension Housing Seal (G1820948): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- Install a new seal.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using the special tool, install the extension housing seal.
  Renew Part: Extension housing seal Quantity: 1.
- Special Tool(s): 307-520
- Special Tool(s): JLR-307-520-01
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the output flange.

Renew Part: Transmission output shaft flange Quantity: 1.
WARNING: Make sure that a new nut is installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using the special tool, install the transmission output flange retaining nut.
  Renew Part: Output shaft flange nut Quantity: 1.
  
  Torque : 60Nm
- Special Tool(s): 205-053
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 48Nm
CAUTION: Care must be taken not to damage the component.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Secure with a cable tie.
CAUTION: Make sure that new bolts are installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the driveshaft.

Renew Part: Driveshaft to front output flange bolts Quantity: 6.

Torque : 75Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the cable tie.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the selector cable.

Torque : 11Nm
Install the transmission support insulator.
Refer to: TRANSMISSION SUPPORT INSULATOR
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT