Transmission Fluid Level Check - Project 8 (G2263327): Adjustment

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Top up the transmission with the recommended transmission oil until fluid flows out of the oil filler hole. Refer to fluid specification.
  Refer to: DESCRIPTION AND OPERATION
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Allow the transmission fluid to drain from the oil filler hole until the flow stops.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using the special tool, install the original oil filler plug.
- Special Tool(s): 307-452
CAUTION: Make sure the transmission fluid fill plug is tightened to the correct specification. Failure to follow this instruction may result in damage to the transmission.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- To make sure the transmission fill plug is torqued to the correct specification. Using the special tool and torque wrench the following calculation steps must be followed.
- Step 1. Multiply 35 Nm by the effective length of the torque wrench (1).
- Step 2. Add the effective length of the special tool (2) to the effective length of the torque wrench (1).
- Step 3. Divide the total of step 1 by the total of step 2.
- Step 4. Set the torque wrench to the figure arrived at in step 3.
- Tighten the transmission fluid fill plug to the torque given by the calculation.
Remove the special tool.
Special Tool(s): 307-452
Clean the area around the filler plug, wipe away any excess fluid and remove the container.
Install the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD - PROJECT 8 (G2248771)
Lower the vehicle.
Disconnect the Jaguar Land Rover approved diagnostic equipment from the vehicle.