Transmission Fluid Level Check (G2247232): Check
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
-
- The following steps must be observed before starting the transmission fluid level check.
- The vehicle must be on a horizontal ramp.
- Make sure that the Electric Park Brake (EPB) is applied.
- Make sure the Transmission Control Switch (TCS) is in the Park (P) position.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
- Remove the air deflector.
Refer to: TRANSMISSION UNDERSHIELD - PROJECT 8
- Lower the vehicle.
-
NOTE: Make sure that the transmission is not in the default mode, if this is the case, stop and correct the cause first and then restart the fluid level check.
- Connect the Jaguar Land Rover approved diagnostic equipment to the vehicle.
- Start the engine and allow to idle.
- Switch off the air conditioning (A/C) system and other electrical components.
-
CAUTION: Using the Jaguar Land Rover approved diagnostic equipment, make sure the transmission temperature is between 30°C (85°F) and 50°C (122°F) before starting the fluid level check.
- Apply and hold the brake pedal.
- Select reverse gear and wait for 10 seconds.
- Select drive, then manual 1st gear and wait for 10 seconds.
- Select 2nd gear and wait for 10 seconds.
- Select Park (P) on the TCS.
- Raise the engine speed to 2000 rpm and hold for 30 seconds. Then return to idle speed.
-
- Using the Jaguar Land Rover approved diagnostic equipment, check the transmission fluid temperature.
General Equipment: Jaguar Land Rover approved diagnostic equipment
- If the transmission oil temperature is lower than 30°C (86°F). Allow the transmission to warm up above 30°C (86°F) with the engine idling in the (P) position, then proceed with the transmission fluid level check.
- If the transmission oil temperature is above 50°C (122°F), switch off the engine and allow the transmission to cool down, then repeat steps 7 and 8.
- Using the Jaguar Land Rover approved diagnostic equipment, check the transmission fluid temperature.
-
CAUTION: Only continue with the fluid level check if the transmission temperature is between 30°C (86°C) and 50°C (122°).
NOTE:
Use a suitable container to collect escaping fluid.
- Remove the oil filler plug.
- If fluid flows out of the oil filler hole, proceed to step 12.
- If fluid does not flow out of the oil filler hole, proceed to step 10.
Special Tool(s): 307-452