Hesitation/Harsh Gear Change
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
AFFECTED VEHICLE RANGE:
| MODEL: | MODEL YEAR: | VEHICLE IDENTIFICATION NUMBER (VIN): | APPLICABILITY: |
|---|---|---|---|
| F-PACE (X761) | 2018 | 249771- 292228 | INGENIUM I4 2.0L Petrol, Vehicles With: 8HP45 8-Speed Automatic Transmission All Wheel Drive (AWD)/8HP45 8-Speed Automatic Transmission Rear Wheel Drive (RWD) |
| XE (X760) | 2018 | P06869- P38100 | INGENIUM I4 2.0L Petrol, Vehicles With: 8HP45 8-Speed Automatic Transmission AWD /8HP45 8-Speed Automatic Transmission RWD |
| XF (X260) | 2018 | Y46487- Y68660 | INGENIUM I4 2.0L Petrol, Vehicles With: 8HP45 8-Speed Automatic Transmission AWD /8HP45 8-Speed Automatic Transmission RWD |
CAUTION:
This procedure requires a minimum of Pathfinder 151 loaded or later.
NOTE:
- Running the Powertrain Control Module (PCM) software update will also automatically check and update the Transmission Control Module (TCM) if required.
- The JLR approved diagnostic equipment will read the VIN for the vehicle and automatically take the vehicle out of 'Transportation mode' if required.
- Connect the JLR approved battery support unit.
- Connect the JLR approved diagnostic equipment to the vehicle and begin 2 a new session.
- Follow the JLR approved diagnostic equipment prompts.
- Select 'ECU Diagnostics'.
- Select 'Update ECU'.
- Follow all on-screen instructions to complete the task.
- If required, reset the vehicle to 'Transportation mode'.
- When all of the tasks are complete, 5 exit the session.
- Disconnect the JLR approved diagnostic equipment and the JLR approved battery support unit.