LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Vehicle Dynamic Suspension -- XE/(760)) >> Vehicle Dynamic Suspension (G1508960) >> Removal And Installation >> Rear Suspension Vertical Accelerometer - Project 8 (G2248936) >> Installation

Rear Suspension Vertical Accelerometer - Project 8 (G2248936): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the rear suspension vertical accelerometer.
    • Install and tighten the 2 nuts.

      Torque  : 7Nm 

    • Install the wiring harness clip.
    • Connect the electrical connector.
  2. Install the luggage compartment right side trim panel.

    Refer to: LUGGAGE COMPARTMENT RIGHT TRIM PANEL

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  4. If a new component has been installed, configure using Jaguar Land Rover (JLR) approved diagnostic equipment.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals