Rear Suspension Vertical Accelerometer (G1818091): Installation
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
-
- Install the rear suspension vertical accelerometer.
- Install and tighten the 2 nuts.
Torque : 7Nm
- Secure the wiring harness clip.
- Connect the electrical connector.
- Install the luggage compartment right trim panel.
Refer to: LUGGAGE COMPARTMENT RIGHT TRIM PANEL
Refer to: LUGGAGE COMPARTMENT RIGHT TRIM PANEL
- Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT