LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Vehicle Dynamic Suspension -- XE/(760)) >> Vehicle Dynamic Suspension (G1508960) >> Removal And Installation >> Rear Suspension Height Sensor - Project 8 (G2248412) >> Installation

Rear Suspension Height Sensor - Project 8 (G2248412): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the rear height sensor.
    • Install and tighten the 3 bolts.

      Torque  : 7Nm 

    • Connect the electrical connector.
  2. Install the rear wheel and tire.

    Refer to: WHEEL AND TIRE - PROJECT 8

  3. Using the Jaguar Land Rover approved diagnostic equipment, calibrate the suspension ride height.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals