LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Vehicle Dynamic Suspension -- XE/(760)) >> Vehicle Dynamic Suspension (G1508960) >> Removal And Installation >> Front Suspension Height Sensor - Project 8 (G2248411) >> Installation

Front Suspension Height Sensor - Project 8 (G2248411): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the front height sensor.
    • Install and tighten the height sensor link pin.

      Torque  : 7Nm 

    • Install and tighten the bolt.

    Torque  : 7Nm 

  2. Install the front wheel and tire.

    Refer to: WHEEL AND TIRE - PROJECT 8

  3. Using the Jaguar Land Rover approved diagnostic equipment, calibrate the suspension ride height.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals