Rear Lower Arm - AWD (G1920721): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.
- Install the rear lower control arm to the vehicle.
- Install and tighten the inner nut and bolt.
  Renew Part: Front lower control arm nut Quantity: 1 .
  
  Renew Part: Front lower control arm bolt(s) Quantity: 1 .
  
  Torque
  
  Stage 1: 100Nm
  
  Stage 2: 180°
- CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.
  Install the rear lower control arm ball joint to the wheel knuckle.
- Install and tighten the nut.
  Renew Part: Front lower control arm nut Quantity: 1 .
  
  Torque
  
  Stage 1: 90Nm
  
  Stage 2: 90°
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.

Install and tighten the front lower control arm nut and bolt.

Renew Part: Rear lower control arm nut Quantity: 1 .

Renew Part: Rear lower control arm bolt Quantity: 1 .

Torque

Stage 1: 60Nm

Stage 2: 135°
CAUTION: Nuts and bolts must be tightened with vehicle at normal ride height.

Install and tighten the front damper yoke bolt.

Renew Part: Shock absorber lower bolt Quantity: 1 .

Torque

Stage 1: 60Nm

Stage 2: 120°
NOTE: If equipped.

Install the height sensor.
Install the wheel and tire.
Refer to: WHEEL AND TIRE
Use the Jaguar Land Rover (JLR) approved wheel alignment equipment, check and if necessary adjust the wheel alignment. SRO 576599 Wheel Alignment Administration to be claimed separately.
Refer to: WHEEL ALIGNMENT