Front Stabilizer Bar - INGENIUM I4 2.0L Diesel (G1920888): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the 2 stabilizer bar mounting rubbers.
- Install the 2 brackets.
- Install the stabilizer bar to the subframe.
- Install and tighten the 4 bolts.
  Torque : 60Nm
- Install the 2 stabilizer bar links.
- Install and tighten the 2 new nuts.
  Renew Part: Stabilizer bar link nuts Quantity: 2 .
  
  Torque
  
  All Wheel Drive: 60Nm
  
  Rear Wheel Drive: 48Nm
Install the front subframe.
Refer to: FRONT SUBFRAME - INGENIUM I4 2.0L DIESEL