LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- XE/(760)) >> Engine Emission Control - INGENIUM I4 2.0L Diesel (G1817202) >> Removal And Installation >> Valve Cover Vent Oil Separator (G1817206) >> Installation

Valve Cover Vent Oil Separator (G1817206): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: Inspect the seals, Replace if damaged.

    Install the valve cover vent oil separator.

    Renew Part: Crankcase oil vent oil separator to cylinder block seals  Quantity: 1. 

    Torque  : 12Nm 

  3. Install the fuel injector wiring harness and secure in position with the 3 retaining clips.
  4. Install the breather pipe onto the valve cover vent oil separator.
  5. Install the Noise, Vibration and Harshness (NVH) pad.
  6. Install the engine cover.
scientia non olet · About LEMON Manuals