High Pressure Exhaust Gas RECIRCULATION Valve (G1868230): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Install the EGR valve.
Torque

1: Upper retaining bolt: 12Nm

2: Lower retaining bolts: 7Nm
- Install the EGR valve inlet pipe.
- Install a new gasket.
  Renew Part: EGR inlet pipe to EGR valve gasket Quantity: 1. Part Number:
- Torque : 12Nm
Connect the 2 coolant hoses.
Connect the electrical connector.
NOTE: This step only applies to vehicles fitted with a high pressure Exhaust gas Recirculation (EGR) cooler.
- Install the high pressure EGR valve to high pressure EGR cooler pipe.
- Install new gaskets.
  Renew Part: Exhaust gas recirculation pipe gasket Quantity: 1. Part Number:
NOTE: This step only applies to vehicles not fitted with a high pressure Exhaust Gas Reciculation (EGR) cooler.
- Install the high pressure EGR valve to intake manifold connecting pipe.
- Install a new gasket.
  Renew Part: Exhaust gas recirculation pipe gasket Quantity: 1. Part Number:
- Install a new O-ring seal.
  Renew Part: EGR pipe to intake manifold O-ring seal Quantity: 1. Part Number:
- Torque
  EGR pipe to EGR valve bolts: 12Nm
  
  EGR pipe to intake manifold bolts: 7Nm
Fill and bleed the cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL