LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- XE/(760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1817213) >> Removal And Installation >> Post Selective Catalyst Reduction Soot Sensor (G1935642) >> Installation

Post Selective Catalyst Reduction Soot Sensor (G1935642): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, install the post Selective Catalyst Reduction (SCR) soot sensor.

    Special Tool(s): JLR-303-1666 

    Torque  : 48Nm 

  2. Install the post SCR soot sensor module to the bracket.
    • Install the wiring harness into the 2 clips.
    • Connect the electrical connector.
    • Install the right side undershield.
    • Install the 5 bolts.

      Torque  : 7Nm 

    • Install the 3 nuts.

      Torque  : 7Nm 

    • Install the 8 fasteners.
  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals