LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- XE/(760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1817213) >> Removal And Installation >> Oil Pressure And Temperature Sensor (G1892882) >> Installation

Oil Pressure And Temperature Sensor (G1892882): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil pressure and temperature sensor.

    Torque  : 15Nm 

  2. Install the wiring harness and connect the electrical connector for the oil pressure and temperature sensor.
  3. Install the accessory drive belt.

    Refer to: ACCESSORY DRIVE BELT

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals