LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- XE/(760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1817213) >> Diagnosis And Testing >> Electronic Engine Controls >> Variable Camshaft Timing Solenoid Inspection And Installation

Variable Camshaft Timing Solenoid Inspection And Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

If a customer complains of a lack of power, accompanied by an induction type noise but no fault exists with the air filter assembly, induction system hoses and no DTC  s are present, the issue is likely to be an internal failure of the variable camshaft timing solenoid.

  1. Install a new variable camshaft timing solenoid as necessary. Refer to: VARIABLE CAMSHAFT TIMING SOLENOID 
  2. Check the date marked on the new variable camshaft timing solenoid, as shown in the image below. If the date shown is 18-08-23 (23rd August 2018) or previous DO NOT  install the solenoid. Only install a new variable camshaft timing solenoid dated after 18-08-23 (23rd August 2018).
G13898032Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC