All Vehicles
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
| Adaptor, Cooling System Vacuum Refill Kit1, 2 JLR-303-1634 |
|
| Balance shaft kit JLR-303-1681 |
|
| Ball Joint Splitter JLR-204-793A |
|
| Ball Joint Splitter JLR-204-793 |
|
| Coolant System Vacuum Refill Kit1, 2, 3 HU-919 |
|
| Engine stand adaptor1, 2, 3, 4 JLR-303-1673 |
|
| Front Cover Alignment Tool JLR-303-1672 |
|
| Installer, Front Wheel Bearing JLR-204-807 |
|
| Installer - Rear Crankshaft Oil Seal JLR-303-1674 |
|
| Installer - Rear Crankshaft Oil Seal JLR-303-1674A |
|
| Knuckle Support JLR-204-836 |
|
| Lifting Bracket, Engine1, 2, 3, 4 JLR-303-1633 |
|
| Locking Tool, Crankshaft Pulley1, 2 JLR-303-1630 |
|
| Remover, Driveshaft1, 2, 3 205-932 |
|
| Remover, Fuel Injector JLR-310-253 |
|
| Remover, Halfshaft1, 2, 205-857 |
|
| Remover, Wheel Bearing 204-305 |
|
| Remover/Installer, Driveshaft Nut JLR-205-993 |
|
| Remover/Installer, Front and Rear Wheel Hub JLR-204-726 |
|
| Remover/Installer, Front Crankshaft Seal JLR-303-1628 |
|
| Remover/Installer, Fuel Pump JLR-303-1627 |
|
| Remover/Installer, NOx/Oxygen Sensor1, 2 JLR-303-1666 |
|
| Remover/Installer, Rear Driveshaft Clamp JLR-205-1033A |
|
| Remover/Installer, Rear Driveshaft Nut JLR-205-1032 |
|
| Slide Hammer 100-012 |
|
| Viscous Coupling Wrench 303-1142 |
|
| Wrench, H02S1, 2 310-121 |
|
| Wrench, Transmission Filler Plug 307-452 |
|
| Engine Lifting Kit JLR-303-1633-01 |