Left Engine Mount (G1817157): Removal

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the air deflector.
Refer to: ENGINE UNDERSHIELD
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the vacuum pipe and reposition away from the engine mount assembly.
Lower the vehicle.
CAUTION: Use a suitable 100mm X 100mm block of wood to support the engine.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable hydraulic jack support the engine as highlighted in the illustration.

General Equipment: Hydraulic floor jacks (2 tonnes minimum capacity)
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
1. Remove the engine mount nut.
2. Release the ground cable and reposition away from the engine mount.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 engine mount retaining bolts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the upper engine mount bracket bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 3 remaining engine mount bracket bolts and remove the engine mount bracket.
NOTE: Note the fitted position of the component prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the engine mount from the vehicle.