LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Engine - INGENIUM I4 2.0L Diesel -- XE/(760) (1 Of2)) >> Engine - INGENIUM I4 2.0L Diesel (G1817138) >> Removal And Installation >> Crankshaft Front Seal (G1817145) >> Removal

Crankshaft Front Seal (G1817145): Removal

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  1. This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  2. This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  2. Disconnect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  3. Remove the crankshaft pulley.

    Refer to: CRANKSHAFT PULLEY 

  4. G11308994Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Using the special tool remove and discard the front crankshaft seal.

    Special Tool(s): JLR-303-1628 

scientia non olet · About LEMON Manuals