Brake Pads - INGENIUM I4 2.0L Diesel (G1822046): Removal
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
- If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
- If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Remove the front wheels and tires.
Refer to: WHEEL AND TIRE
-
NOTE: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
-
CAUTION: Do not allow the brake caliper to hang on the brake hose.
Tie aside.