Brake Caliper - INGENIUM I4 2.0L Petrol/V6 S/C 3.0L Petrol (G1822041): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the wheel and tire.
Refer to: WHEEL AND TIRE
NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the access cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the anti-rattle spring.
CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.

NOTE: Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect and release the brake pad wear sensor.
CAUTION:
- Inspect the brake hose sealing washers for signs of damage, if damage is present discard the sealing washers.
- Be prepared to collect escaping fluids.
NOTE: Make sure that all openings are sealed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the brake caliper hose from the brake caliper.
- Disconnect the brake pipe union.
- Remove the clip.
- Remove and discard the brake caliper hose.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 dust caps.
Undo the 2 brake caliper 2 slide pins.
Remove the brake caliper.