Updating the Vehicle Maps

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When you have a USB stick with the maps downloaded onto it, you can update the maps on a vehicle.

The VIN of the vehicle where you are installing the maps must match one of the license keys on the USB stick. If there is no corresponding license key, you cannot install the maps on that vehicle.
If you have trouble getting the map updates to work, try using a different USB stick.

The engine must be running or in Electric Vehicle (EV) ready mode during the entire map update process to make sure that the vehicle's power-saving measures do not interrupt the update.

Start the engine of the vehicle.
Start the vehicle's navigation system.
Insert the USB stick into the USB slot in the vehicle. The application performs various checks on the data on the USB stick and informs you what actions to take if there are problems.
- The vehicle must be stationary when you start the map update process. You may start driving after the update process starts but, to begin with, the vehicle must be stationary.
Follow the instructions given by the navigation system. The application shows a progress dialogue while the update is ongoing. It might take around 15 minutes for the update to finish depending on the size of the map data. Click Cancel if you want to abort the update.
- You may start driving the vehicle when the map update starts. However, you cannot use the navigation system while the update is in progress. Make sure the ignition is on and the USB stick remains inserted until the update is complete. In case of any errors, the application informs you about how to proceed.
When the update is complete, remove the USB stick and then click Continue . The application then shuts down and restarts.
Click Continue to return to the home screen. 'Check that the map appears on screen and input a sample post code to check the system is functioning correctly.