Performing Content Update
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
After the newest content files are downloaded, perform the update on the navigation subsystem.
NOTE:
Do not switch off the navigation system during the following process, and do not remove the USB storage device until the preparation process is completed.
The engine must be running or in EV ready mode during the entire map update process to make sure that the vehicle's power-saving measures do not interrupt the update.
- Start the navigation subsystem .
- Insert the USB storage device that contains the downloaded content into the USB plug of the head unit.
- Tap Yes on the upcoming confirmation screen.
- The software update starts and a progress bar shows the status of the process.
- When the update has completed, remove the USB storage device and tap Restart to validate the uploaded content.
- After the restart, the uploaded content is used by the navigation system.