LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 200 (Electronic Engine Controls - V8 S/C 5.0L Petrol, Project 8 -- XE/(760)) >> Electronic Engine Controls - V8 S/C 5.0L Petrol, Project 8 (G2261903) >> Removal And Installation >> Left Heated Oxygen Sensor (G2244152) >> Installation

Left Heated Oxygen Sensor (G2244152): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure that the mating faces are clean and free of corrosion and foreign material.
    • Make sure the anti-seize compound does not contact the HO2S tip.
    • If accidentally dropped or knocked install a new sensor.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

    Using the special tool, install the left Heated Oxygen Sensor (HO2S).

    Special Tool(s): JLR-303-1666 

    Torque  : 48Nm 

  2. Install the left catalytic converter.

    Refer to: LEFT CATALYTIC CONVERTER

  3. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD - PROJECT 8

scientia non olet · About LEMON Manuals